Technogym Skillmill - 12.4 REVISION 2.2; 12.5 REVISION 2.3; 12.6 REVISION 2.4; 12.7 REVISION 2.5

Skillmill
Technical Service Guide - Rev. 3.5
Page 130
email: support@technogym.com
§6.3.2: Wi-Fi connection.
§9: SW update.
12.4 REVISION 2.2
Change to paragraph 2.2 Environmental characteristics, 3.1.10 Wi-Fi (Connect version), 5.2 Lifting
and moving the equipment, 9 SW update, 3.1.5 RPM sensor.
New paragraph 6.5.6: Abnormal speed shown on the display (Console version).
“WI-FI connection” paragraph eliminated because it is redundant.
12.5 REVISION 2.3
Change to paragraph 8. ADJUSTMENTS AND REGULATIONS.
12.6 REVISION 2.4
Detailed description of the command seing procedure in paragraph 6.4 DISPLAY
CONFIGURATION.
Change to paragraph 6.6 BRAKE TABLE CALIBRATION: procedure updated.
Change to paragraph 3.1.5 RPM SENSOR: distance between the RPM sensor and magnet updated.
New paragraph 6.5.8: BATTERY-POWERED SKILLMILL THAT TURNS ON AND OFF
REPEATEDLY: new troubleshooting procedure.
New paragraph 6.5.9: SKILLMILL THAT DISPLAYS AN INCORRECT SPEED ON THE LCD/
TURNS OFF AT A LOW SPEED: new troubleshooting procedure.
New paragraph 7.13: FASTENING THE BELT PULLEY GRUB SCREWS.
New paragraph 7.14: SNAP RINGS INSIDE AND OUTSIDE THE PULLEYS: product change.
12.7 REVISION 2.5
Updated paragraph 6.3.1 STEPS NECESSARY FOR CONFIGURING THE SKILLMILL CLASS.
Change to paragraph 6.5.4 THE EFFORT LEVEL DOES NOT CHANGE ON THE DISPLAY: note
added regarding the troubleshooting procedure for equipment with a faulty pin.
New paragraph 6.5.7: THE EFFORT LEVEL CHANGES ON THE DISPLAY WITHOUT ANY
CHANGE IN THE LEVER POSITION: note added regarding the troubleshooting procedure for
equipment with a faulty pin.
New troubleshooting item: “Skillmill that does not turn on” in paragraph 6.5.9 BATTERY-
POWERED SKILLMILL THAT TURNS ON AND OFF REPEATEDLY/ SKILLMILL THAT DOES
NOT TURN ON.
New paragraph 7.15: POSITIONING THE BRAKE UNIT LIMIT SWITCH SCREW.
Change to note in paragraph 7.7.2 REPLACING THE BRAKE CABLE.