Technogym Skillmill - Page 51

6.3.3 WI-FI AND NETWORK CONFIGURATION
 Seingstobeconguredbytheclub.
6.3.3.1 SETTING A NAME FOR THE NETWORK
Command Notes
Command @SWIFISSID ssid#
Sets the SSID of the access point that the console
must connect to.
Table 36
The parameter ssid indicates the name of the Wi-Fi network.
6.3.3.2 WRITING THE ACCESS POINT PASSWORD
Command Notes
Command @SWIFIKEY key#
Sets the password of the access point that the
console must connect to.
Table 37
The parameter key indicates the value of the access point password. If the access point does not have
a password, write only @WIFISETKEY#.
6.3.3.3 WRITING THE WEP KEY NUMBER
Command Notes
Command @SWEPKEYINDEX index#
Sets the number of the WEP key used to connect
to the access point with WEP encryption.
Table 38
The parameter indexindicatesthenumberoftheWEPkeyused(thepermiedvaluesare1,2,3and
4). If a WEP key is not used, enter 0. Only WEP open key mode is supported.
Skillmill:
Technical Service Guide - Rev. 3.5
Page 51email: support@technogym.com