Technogym Skillmill - Page 53

6.3.3.7 CHECKING THE IP ADDRESS - DEFAULT GATEWAY - NETMASK
Command Notes
Command @RNETPARAM#
Displays the IP address of the console, the
default Gateway and the netmask the console
is currently using (regardless of whether these
have been assigned in DHCP mode or have
beenconguredasstatic).
Table 42
6.3.3.8 READING THE WI-FI POWER
Command Notes
Command @RWIFIRSSI# ShowstheincomingWi-power.
Table 43
The signal must be above -85dBm (e.g. -80dBm = OK).
6.3.4 CONFIGURING UNITY SELF
6.3.4.1 SETTING THE PARAMETERS
Command Notes
Command @SRTMSOCKET ip_add port#
Sets the IP address and the UDP port where
Unity Self is located.
Table 44
The parameter ip_add indicates the IP address where Unity Self is located. The parameter port
indicates the number of the UDP port where Unity Self is located.
6.3.4.2 SETTING THE DATA SEND PERIOD
Command Notes
Command @SRTMPOLLING tsend# Sets the period for sending data to Unity Self.
Table 45
Skillmill:
Technical Service Guide - Rev. 3.5
Page 53email: support@technogym.com