Technogym Skillmill - Page 54

The parameter tsend indicates the data sending period to Unity Self (expressed in seconds).
6.3.4.3 DISPLAYING THE MONITOR CONFIGURATION
Command Notes
Command @RRTMCONFIG# DisplaystheUnitySelfconguration.
Table 46
6.3.4.4 ENABLING DATA SENDING
Command Notes
Command @ENABLERTM# Enables the sending of data to Unity Self.
Table 47
6.3.4.5 DISABLING DATA SENDING
Command Notes
Command @DISABLERTM# Disables the sending of data to Unity Self.
Table 48
6.3.5 CONFIGURING THE DISPLAY
6.3.5.1 SETTING THE DISPLAY TO ON IN STANDBY
Command Notes
Command @SDISPLAYONSTANDBY#
Congures the Connect equipment so the
display is switched on in standby mode.
Table 49
Skillmill
Technical Service Guide - Rev. 3.5
Page 54
email: support@technogym.com