Technogym Skillmill - Page 55

6.3.5.2 SETTING THE DISPLAY TO OFF IN STANDBY
Command Notes
Command @SDISPLAYOFFSTANDBY#
Congures the Connect equipment so the
displayisswitchedoinstandbymode.
Table 50
6.3.6 CONFIGURING TIME-OUT
6.3.6.1 SETTING TIME-OUT
Command Notes
Command @SCLOSEEXTIMEOUT tmout#
Sets the time-out after which (when the speed
measurement is 0) the exercise is terminated
and the summary is shown.
Table 51
The tmout parameter indicates the time-out value (expressed in seconds).
6.3.6.2 VISUALISING TIME-OUT
Command Notes
Command @RCLOSEEXTIMEOUT#
Displays the time-out after which (when
the speed measurement is 0) the exercise is
terminated and the summaryis shown.If 0is
displayed, this means the time-out has not been
set so the default value of 5 secs with be used.
Table 52
Skillmill:
Technical Service Guide - Rev. 3.5
Page 55email: support@technogym.com