Technogym Skillmill - Page 57

6.3.8.2 SETTING THE DATE AND TIME
Command Notes
Command
@SETDATE dd mm yyyy hh mn

Congures the date and time in the RTC. The
parameters to be set are:
▪ dd: day of the month
▪ mm: month
▪ yyyy: year
▪ hh: hours
▪ mn: minutes
▪ ss: seconds
▪ :timezone(theminutesofdeviation
from UTC must be entered. If you are
located east of Greenwich, the value
will be positive, otherwise it will be
negative. As a reference for Italy,
when Standard Time is being used,
thedeviationis+60minutes,whereas
it is +120 minutes during Daylight
Saving Time. If you enter the time,
setUTCto0.
Table 56
The calibration of the RTC is important for the correct functioning of the Cloud services via TLS/SSL.
6.3.8.3 READING THE DATE AND TIME
Command Notes
Command @GETDATE# Prints the current date and time.
Table 57
Skillmill:
Technical Service Guide - Rev. 3.5
Page 57email: support@technogym.com