Technogym Skillmill - Page 84

Figure 49 - rear shaft reference distance
4. Addamediumthreadlocker(e.g.Loctite243)onthethreadofeachoftheangebearinggrub
screws on the rear and front shaft of the equipment.
5. Tightentherstbearinggrubscrewto4.5Nm(3.32lbf-ft).Tightenthesecondgrubscrewto
4.5Nm(3.32lbf-ft).Tightentherstgrubscrewagain,to4.5Nm(3.32lbf-ft).
.
Skillmill
Technical Service Guide - Rev. 3.5
Page 84
email: support@technogym.com