Technogym Skillmill - 6.9 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNICAL SERVICE

4. Check that the date and time correspond using the command @GETDATE#. The time should
be afewsecondsahead(timepassedbetweenseingandreadingthedateandtime).
5. DisconnecttheUSB-MINIUSBcablefromtheconsole.Wait10seconds.ReconnectthePC
to the console using the USB - MINI USB cable. From the terminal, launch the read date and time
command @GETDATE#. The date and time must correspond with what is set. The time should be a
fewsecondsahead(timepassedbetweenseingandreadingthedateandtime).
6.9 EQUIPMENT TESTING AFTER THE INTERVENTION OF TECHNICAL
SERVICE
After a technical service intervention, the technician MUST check - in the same conditions in which
the customer discovered the problem - that the fault has been resolved.
The technician MUST also perform the following standard operating tests:
TEST: do an exercise and check that the resistance changes according to the position of the lever.
TEST: in the case of Skillmill Console and Connect: make sure the information on the display is
correct.
TEST: in the case of Skillmill Connect: make sure the login on the machine is made correctly, via
the TGS key, mywellness key, NFC, QR code.
TEST: check the condition of the power supply cable.
Skillmill:
Technical Service Guide - Rev. 3.5
Page95email: support@technogym.com