IPCAM User Manual
19
4.43 For Administrator
When you login as administrator, you can set all parameters. Please click “For Administrator” and enter into
setting interface .
Picture 24
Alias Settings: You can Input the new name as you like.
Data &Time Settings: Data &Time Settings page.
Users Settings: Eight accounts are acceptable for this system. Here the eight users can configure their
user names and password as Administrator, Operator or Visitor.
l Visitor: In this mode, you can only view.
l Operator: You can control the direction of IP Camera and set some parameter.
l Administrator: You can setup the advanced configurations of the IP Camera.
UpnP Settings: If you access IP Camera, to be make sure UpnP Status is Succeed.
Upgrade Device Firmware: Upgrade Device Firmware and device embeded web UI software in this
page.
Restore Factory Settings: Restore factory settings of the device.
Reboot Device: Reboot the device.
Back: Back to Monitoring Mode.
View Device ID、Device Firmware
Version and Device Embedded
Web UI Version
Check Device all kinds of
status
Carry on Settings and
operation function
To Next Page
Loading...
