TECHVIEW IP Camera - Some Special Application for IPCAMERA

IPCAM User Manual
55
picture 107
3、How to set DDNS on line?
The first way：Menu ”start”- “run”—> Input CMD，Clink ”enter”。It can check DDNS Statas
via. As shown below：
Picture 108
Through the PING command, this dynamic domain name can be back in the network response information. It
proves that the domain name has been online.
If the domain name update not success! Possible reasons: (1) DDNS parameter is not correct. (2) may
cause: DNS address configuration is wrong.
8.2 Some special application for IPCAMERA
IPCam：
Use some grammar parameter control and Use IPCam
user：user
pwd：password
pri：
The current access (1: visitors 2:3: operator managers)
resolution：
Image resolution
（8：320*24 0qvga，32：640*480 vga）
rate：
mage transmission speed and scope
0-23