TECOM Challenger10 - Option 5 History

Chapter 3: Menu reference > Option 5 History
20 Challenger10 Administrators Manual
No Isolated Inputs.
Press ENTER
When one or more inputs are isolated, the LCD screen displays the inputs. If you
see only numbers and no names, refer to “Displaying input names” on page 8.
Isolated On 2, Front Door Contact
NEXT or ENTER
Press [ENTER] to exit the option. Alternatively, press [NEXT] to display additional
isolated inputs, if any.
Option 5 History
From the User menu prompt (see “Using the keypad” on page 7), press
[5] [ENTER] to display past events of system history, including alarms and
access to the menu. It can help you determine events such as the time that an
alarm occurred, the time it was reset and who reset it, the time the system was
disarmed in the morning, and so on.
1-Alarm Events 2-Log Only Events
Option:
Press [1] [ENTER] to display alarm events currently held in the panel’s memory.
13:49 26/11 Menu Entered at Console 1 >
1-Scan, 0-Exit
The display indicates the most recent event. A > character at the end of the line
indicates that the text does not fit on the LCD screen. Press [1] to shift the text
sideways to see more, and repeat as needed. A * character at the start of the line
indicates that the event is an alarm activation.
Press [ENTER] to view earlier events, or press [NEXT] to view later events.
The above example shows:
• The time of the event in hours and minutes (HH:MM).
• The date of the event as day and month (DD/MM).
• The type of event, for example, Menu Entered.
• The location of the event, for example, Console (RAS) 1.
• The user’s number and name (if applicable). In this case, press [1] to shift the
text sideways to see the additional text.
Enter [2] and press [ENTER] to display events currently held in the panel’s
memory that are not reported to the monitoring station but sent to local printer or
computer (for example, access granted at door).