TECOM Challenger10 - Option 22 Open Door; Option 23 Unlock, Lock, Disable and Enable

Chapter 3: Menu reference > Option 22 Open Door
46 Challenger10 Administrators Manual
Alternatively, to remove a holiday type from a holiday (it’s already displayed in
the top line of the LCD screen), enter the number, and then press [ENTER].
Recurring holidays
NO - Recurring Holidays
*-Change 0-Skip
If required, press [MENU*] to toggle the programmed value from NO to YES, and
then press [ENTER]. Alternatively, press [0] to exit this holiday.
When a future holiday is defined as recurring, then the year portion of the start
and end dates is automatically incremented by 1 each time the holiday ends.
Option 22 Open Door
From the User menu prompt (see “Using the keypad” on page 7), press
[2] [2] [ENTER] to unlock a door that you (and the RAS) are authorized to unlock.
The Open Door command would typically be used at a RAS that’s at a different
location from the door (for example, from a security desk).
Open Door
Door No:
Enter the door number in the range 1 to 128 and then press [ENTER].
Alternatively, press [ENTER] to exit this option.
Option 23 Unlock, Lock, Disable and Enable
From the User menu prompt (see “Using the keypad” on page 7), press
[2] [3] [ENTER] to unlock, timed unlock, lock, disable, or enable an intelligent
door (doors numbered in the range 17 to 64 or 81 to 128 connected to an
Intelligent Access Controller).
The door will remain in the state selected until an opposite event occurs in the
system that will change the state of that door. For example, door 21 automatically
unlocks at 8 a.m. and relocks at 5 p.m. by using an override time zone. If the
user wishes to secure the premises and leave at 4 p.m., the door can be locked
using the lock option, but will still automatically unlock at 8 a.m. again the
following morning.
1-Unlock 2-Lock 3-Disable 4-Enable
Option: