TECOM Challenger10 - Option 14 Program Users

Chapter 3: Menu reference > Option 14 Program Users
30 Challenger10 Administrators Manual
Option 14 Program Users
From the User menu prompt (see “Using the keypad” on page 7), press
[1] [4] [ENTER] to manage the user records that are stored in the Challenger
panel’s memory. For tasks involving large quantities of users it’s best to use
management software such as Security Commander.
Note: Your Challenger system may be configured for dual custody programming,
where any user (other than the master user) requires a second user to enter their
code before access is granted to this option.
1-Delete 2-Display 3-Create 4-Total 5-Card Learn
Option:
The Program Users menu contains the following options:
• 1—see “Delete user” below.
• 2—see “Display user” below.
• 3—see “Create (or modify) user” on page 32.
• 4—see “Total users” on page 36.
• 5—see “Card learn” on page 36.
• Press [0] [ENTER] to exit this option.
See also “Programming non-Tecom magnetic card formats” on page 36.
We suggest that you record the details of users on the User worksheet (see
“Users worksheet” on page 50).
Delete user
From the Program Users menu, press [1] [ENTER] to delete a user.
Delete User
User No:
Enter the user number and then press [ENTER] to delete the user record. Repeat
if needed for another record.
Press [ENTER] again to exit this option.
Display user
From the Program Users menu, press [2] [ENTER] to display a user’s details
(assuming that you permissions to view the user).