TECOM Challenger10 - Option 18 Reset Cameras; Option 19 Install Menu

Chapter 3: Menu reference > Option 18 Reset Cameras
Challenger10 Administrators Manual 41
Enabling the service technician activates the special soft time zone 25, which is
used to enable the service technician’s PIN or card, and can also be used to
enable or disable other system functions, relays, etc., that are required while the
service technician is in attendance.
0-Cancel, 1-Service In
Option:
From the Enable/Disable Service Tech menu, press [1] [ENTER] to enable the
service technician for the programmed service time period and to exit to the
menu.
If not expired, the programmed service time period may be extended by
reactivating the option. Press [1] [ENTER] during the service time period or
Service Ending warning to reactivate.
If you need to cancel the service technician’s PIN or card before the service time
expires, press [0] [ENTER].
Option 18 Reset Cameras
From the User menu prompt (see “Using the keypad” on page 7), press
[1] [8] [ENTER] to reset the film frame count on all security cameras connected
directly to the Challenger panel to zero or to change the frame count number on
an individual camera. This would be necessary when you change the film in the
camera.
Reset Camera Counts “0#”-All
Camera No:
Press [0] [ENTER] to reset the film frame count on all security cameras to zero.
Press [n] [ENTER] to display the current film frame count on camera n. Press
[ENTER] a second time to return to the Reset Camera screen.
Alternatively, enter a new frame count in the range 0 to 1900 for the selected
camera, and then press [ENTER] to return to the Reset Camera screen.
Option 19 Install Menu
Access to the Install menu is typically limited to installers or administrators. Refer
to the Challenger10 Programming Manual if you are an installer or administrator
and you need to know details of Challenger system programming.