Chapter 3: Menu reference > Option 8 Film Counters
Challenger10 Administrators Manual 25
Option
8 Film Counters
From the User menu prompt (see “Using the keypad” on page 7), press
[8] [ENTER] to display the current frame number position on each of the security
camera films.
If a camera is fitted with a film out detector and that camera does not have a film
in it, the frame count will be displayed as OUT (OUT is removed when film is
loaded).
Up to eight cameras can be displayed. A camera position that does not have a
camera fitted will display the frame count as ‘----’.
A frame count can be from 0 to 9999.
Film Counts 1: 0123 2:1077 3:0056 4:----
Press ENTER
Press [ENTER] to see the film counts for cameras 5 to 8. Press [ENTER] a
second time to exit this menu.
Option
9
Input Text
From the User menu prompt (see “Using the keypad” on page 7), press
[9] [ENTER] to display the names assigned to inputs 1 to 1008.
Input: 1, Rear Door Contact
Input No:
The LCD screen displays the first input number and its assigned name. If you
see only numbers and no names, refer to “Displaying input names” on page 8.
Press [NEXT] or [MENU*] to display subsequent input names. Alternatively, enter
the input number and press [ENTER] to display the input’s name.
Press [ENTER] to exit the display.
Option
10 Isolate
You may need to isolate an input to prevent false alarms (possibly due to a faulty
input device). A faulty input is typically unsealed, and cannot be sealed. Isolating
the input excludes it from functioning as part of the intrusion detection system.
If an input is in an alarm state, then isolating it resets the alarm. After the problem
is resolved the input must be de-isolated (see “Option 11
Deisolate
” on page 26).
From the User menu prompt (see “Using the keypad” on page 7), press
[1] [0] [ENTER]. The LCD screen displays the first unsealed input or the message
“All Inputs are Sealed”.
To Next Page
Loading...
