Chapter 3: Menu reference > Option 6 Test Report
22 Challenger10 Administrators Manual
Untested Access On 25, Reception Hold Up
NEXT or ENTER
Press [NEXT] to update the list of untested inputs, and to display the remaining
inputs in the list (if any).
Press [ENTER] to display the results of camera testing (cameras in area 1 only).
If all the cameras that are programmed to be tested (including 0 cameras) have
been successfully tested the LCD screen displays the following.
All Cameras Have Tested Successfully
Press ENTER
Press [ENTER] to exit the option.
Use “Option 12 Test Input” on page 26 to manually test any untested inputs
reported.
Secure test report
This option is used to display the results of the secure (armed) test, which can be
performed on specific inputs to see if they are operating correctly. The inputs
must be programmed to be included in secure tests (determined by the input’s
test type). The system must be programmed with an appropriate test mode.
From the Test Report menu option, enter [2] and press [ENTER] to display the
results of inputs tested during secure tests. If all inputs that are programmed to
be tested (including 0 inputs) have been successfully tested the LCD screen
displays the following.
No Untested Inputs.
Press ENTER
Alternatively, when one or more inputs are untested, the LCD screen displays the
inputs. If you see only numbers and no names, refer to “Displaying input names”
on page 8.
Untested Secure On 17, Rear Door Contact
NEXT or ENTER
Press [NEXT] to update the list of untested inputs, and to display the remaining
inputs in the list (if any).
Press [ENTER] to exit the option.
Use “Option 12 Test Input” on page 26 to manually test any untested inputs
reported.
To Next Page
Loading...
