Tecsun PL-660 - ALARM SETTING (By Radio only); SETTING THE ALARM STATION; SETTING THE ALARM TIME

www.tecsunradios.com.au
14...................................................................................PL-660
flashing
SETTING THE ALARM STATION:
1. Turn on the radio, then tune into your favorite station for alarm by
radio and adjust your desired alarm volume level.
2. Press the [MEMORY] button and then immediately press the
[TIMER A] or [TIMER B] button and notice “ ” or “ ”
flashing on the display to confirm the preset alarm station.
SETTING THE ALARM TIME
1. Press & hold the [TIMER A] button
with hour flashing in the upper right
corner of display, then rotate the
knob to adjust the hour.
2. Press the [TIMER A] button with
minutes flashing, and then rotate
the [TUNING] knob to adjust the
minute.
3. Press the [TIMER A] button again,
then rotate the [TUNING] knob to
select from 1 ~ 90 minutes to set
the Alarm Off Timer.
4. Press the [ ] button to
confirm the setting.
※ If the [TIMER A] button has not been pressed again within 3
seconds, the unit will automatically confirm the alarm setting.
Note: The unit will turn on automatically and switch to the preset
alarm station and time. It will also be turned off automatically when it
reaches the preset time.
[TUNING]
TIMER A
ALARM SETTING (By Radio only)
Ni-MH
Battery
A
SL EEP
Timer A
Setting timer for alarm off
A
B