Tecsun PL-660 - SETTING TUNING STEP; FM ST. (FM STEREO)

www.tecsunradios.com.au
16...................................................................................PL-660
The intelligent tuning step function is
activated by default. You can also press &
hold the [STEP] button to select fast /
slow tuning with radio on. FAST/SLOW
tuning is shown in the chart below for
each band.
SETTING TUNING STEP
TUNING
STEP
Slowly rotate the
[TUNING] knob with
“Slow” indicates on
display
FAST/SLOW TUNING STEP
(”Fast/Slow” flashing on display)
0.01 MHz
1kHz
Quickly rotate the
[TUNING] knob with
“Fast” indicates on
display
0.1MHz
9kHz / 10kHz
9kHz
5kHz
Quickly / Slowly rotate the
[TUNING] knob
0.01MHz 0.01MHz
Long-press
SLOW
25kHz
1kHz 1kHz
1kHz 1kHz
1kHz 1kHz
1kHz
1kHz
1kHz
1kHz 1kHz
flashing
FM
MW
LW
SW
AIR
BAND
S LOW TUNING STEP
Slow” flashing on display)(”
1. While listening to FM stereo stations, press the [FM ST.] button
with “ ” appears in the display to activate the “STEREO”
listening. If the received FM broadcast signal is too weak, it is
recommendable to turn off the stereo function by pressing the
[FM ST.] button again with disappears.
2. While listening to FM stereo stations by speaker, it is
recommendable to turn off the stereo function by pressing the
[FM ST.] button with disappears to improve sound quality.
3. The stereo function will not be activated and will not
appear if the FM station is not stereo broadcasting.
“ ”
“ ”
“ ”
FM ST. (FM STEREO)