Tecsun PL-660 - How to Select Different Memory Page; Delete Single Memory Manually; Semi-Auto Delete Memory

www.tecsunradios.com.au
1. Press the [FM], [MW/LW] or [SW]
button for band selection, then tune
into your desired station.
2. Press the [MEMORY] button with
memory address flashing on the
upper right corner
3. Press the [ - PAGE + ] button to
choose your desired memory PAGE,
then rotate the [TUNING] to select
your preference memory address.
4. Press the [MEMORY] button again
to confirm or wait for 3 seconds to
auto store the station into memory.
HOW TO SELECT DIFFERENT MEMORY PAGE
Press
10...................................................................................PL-660
WORKING WITH STATION MEMORIES
DELETE MEMORY
Press the [VF / VM] button with “Memory address” showing on upper
right corner of the display to enter the [Memory] mode, and then
follow below methods to delete those unwanted stations
METHOD 1: DELETE SINGLE MEMORY MANUALLY
Rotate the [TUNING] knob to select
the memory that you want to delete,
press & hold the [DELETE] button
with “ ” flashing; then press the
[DELETE] button to remove the
unwanted memory address.
Note:
If “ " is flashing more than 3 seconds without confirmation, it will
exit the delete function automatically.
METHOD 2: SEMI-AUTO DELETE MEMORY
Press and hold the[VF / VM] to auto browse stations, then you can
press the [DELETE] button anytime to direct delete the unwanted
station; the radio will keep on auto browsing the next available
station until you press any other button to stop this function.
0 1 2 3 4 5
Ni-MH
Battery
PAGE PRESET
Delete Single Memory
flashing