www.tecsunradios.com.au
PL-660...................................................................................21
Note: This radio is default to use rechargeable batteries for power
supply. In case of using regular batteries, you should switch the radio
system to regular batteries mode in order to show the correct power
capacity.
If the radio does not function properly,
you can perform a reset by using a
pointed object such as straightened
paper clip, into the [RESET] hole in the
bottom of the unit, and gently press and
release.
Note:
Station memory will not be removed after
you push the reset button.
RESET PROCEDURE
RESET
RESET
Located at the botton of radio
1. The Clock memory will be gone if the unit has no power supplied
by either batteries or adaptor for a long time, but the pre-stored
frequencies will still be kept.
2. When the battery power is low, the " " symbol in the display
will flash to alert you for changing new batteries. And it will turns
off automatically when the power is gone.
3. Mix using the used & new batteries would cause damage of radio
and incorrect display of power capacity.
4. In order to avoid leakage, always remove the batteries when the
unit will not be used for a long period of time.
IMPORTANT MATTERS FOR USING BATTERIES
To Next Page
Loading...
