Tecsun PL-660 - LISTENING TO STORED STATIONS; Memory Tuning Manually; Auto Browse Memory; Direct Key in Memory Address

www.tecsunradios.com.au
12...................................................................................PL-660
flashing
Select band and then press the
[VF / VM] button with “Memory
address” shows on the upper right
of display to enter the
mode, press the [ - PAGE + ]
to select your desired page,
any of below three tuning
tune around those stored
stations:
METHOD 1: MEMORY TUNING MANUALLY
Rotate the [TUNING] knob to tune around the stored station.
METHOD 2: AUTO BROWSE MEMORY
Press & hold the [VF / VM] button
until “PRESET” flashing to auto scan
from one memory to another, staying
on each station for about 5 seconds.
To stop auto search memory, simply
rotate the [TUNING] knob or to press
on [VF / VM] button again.
METHOD 3: DIRECT KEY IN MEMORY ADDRESS
Press the numeric keys [0] - [9] to enter the memory address
directly, and then press again the button to confirm.
Note: If the display shows “ ” symbol after entering the
number, it means the entered memory page/address does not exist.
corner
[Memory]
button
then apply
methods to
LISTENING TO STORED STATIONS
BW
kHz
MW
SL EEP
PAGE PRESET
Ni-MH
Battery
0 1 2 3 4 5
Changing memory pages
flashing
Auto browse memory
MHz
SL EEP
PAGE PRESET
Ni-MH
Battery
FM
0 1 2 3 4 5