Tecsun PL-680 - Alarm Setting (By Radio only); Setting the Alarm Station; Setting the Alarm Time

TECSUN RADIOS AUSTRALIA
www.tecsunradios.com.au
14 PL-680
flashing
SETTING THE ALARM STATION:
1. Turn on the radio, then tune into your favorite station and adjust
your desired alarm volume level.
2. Press the [MEMORY] button and then immediately press the
[TIMER A] or [TIMER B] button and notice “ ” or “ ”
flashing on the display to confirm the preset alarm station.
SETTING THE ALARM TIME
1. Press & hold the [TIMER A] button
until the hours indicator starts
flashing in the upper right corner of
the display. Rotate the [TUNING]
knob to adjust the hours, or directly
enter the alarm time by pressing the
[ 0 – 9 ] numeric keys.
2. While the hours indicator flashes,
press the [TIMER A] button to select
the minutes indicator. Rotate the
[TUNING] knob to adjust the
or directly enter it by
[ 0 – 9 ] numeric keys.
3. Press the [TIMER A] button again,
then rotate the [TUNING] knob to
select from 1 - 90 minutes to set the
"Alarm Off Timer". This is the time
duration after which the radio will be
turned off automatically.
4. Press the [ALARM] button to confirm
the setting or wait for 3 seconds, the
unit will automatically confirm the
alarm setting.
Note: Follow the above instructions using the [TIMER B] button to
set a second alarm.
minutes,
pressing the
ALARM SETTING (By Radio only)
Ni-MH
Battery
A
SL EEP
Timer A
Setting timer for alarm off
A
B