115-0701-001 - 44 -
Accessories
Add On Bed Extension: 55195
Extend the bed of your Nova DVR XP Woodlathe for
greater capacity for turning between centers. Each bed
unit adds 510mm (20in.)
Lathe Stand
The stand pieces are cast from a high grade of Cast iron
with extremely good section thickness and CAD generated
internal gussets at all critical points to withstand extremely
high stresses with practically no distortion. Cast iron has
always been the material of choice for wood lathe
construction because of its inherent mass and excellent
modulus of vibration dampening. The cast iron stand has
been purposely designed to be heavy, solid and robust
keeping this in mind.
“New” Hybrid Stand
The hybrid stand is a combination of cast iron and
rectangular hollow section. Compared to its original
predecessor, the hybrid was designed to be light weight
and style.
Small Toolrest: TR100/1
A small 100mm (4in.) toolrest (not shown) for turning
small work pieces or reaching into recessed areas.
Bowl Toolrest:
A curved toolrest, which gives you better chisel support on
both the outside and inside of a bowl. Because of the
curve you are able to position your chisel support closer to
the bowl.
Revolving Center System: NLCS or NLCS1
A multi-function live center system to expand your options
when turning between centers. It includes quick change
tapers: a hollow cup center point, threaded center, cone
center, and an extension center. Made with three bearings
and precision machined for a high quality finish.
Handwheel Unit: LHB
The handwheel is mounted on the outboard end of the
headstock spindle so you can manually position work or to
slow it down. The vacuum coupler can also be added to
this unit to make a vacuum holding option.
To Next Page
Loading...
