Specification-31
4
Service
TABLE
1-1
(cont)
5 cycles (120 hours) of MIL-I-6181D.
Omit freezing and vibration. Post
test after drying period at
+25"C,
t5"C at 20% to 80% relative
humidity
Performance Requirement
15 minutes along each of the 3
major axes at a total displace-
ment of 0.025-inches,
peak-to-
peak (4 g's at 55 cycles/sec) with
frequency varied from 10 to 55 to
10 cycles/sec in 1-minute cycles.
Hold for 3 minutes at 55 cycles/
sec. All major resonances must
be above 55
cycles/sec
Supplemental Information
30 g's, 1/2 sine, 11 ms duration, 2
guillotine-type shocks per axis for
a total of 12 shocks
150 kHz to 1000 MHz
1 hour slightly in excess of 1 g
30 inches on any corner, edge or
flat surface
Physical Characteristics
-
Net, wlthout
accessories
10 pounds
(4
7
k~lograms)
Shlpplng, Domest~c
19 4 pounds (8 8 k~lograms)
Characteristic
Warmup Time
I
See Fig 1-2.
Performance Requirement
Supplemental Information
At least 5 minutes
To Next Page
Loading...
