GPIB
370B User Manual
Power on – This occurs when the power is turned off, then turned back on.
Operation–complete –This status byte is set when certain operation is complete.
User request – Occurs when the front–panel SINGLE button is pressed while
holding down the FAST/SHIFT button.
Collector supply recover –This status byte is set when PLL error or Series-resis-
tor overheat error is recovered.
Command error – This status byte is set when a message cannot be parsed or
recognized.
Execution error – This status byte is set when a message is parsed and is
recognized, but cannot be executed, such as AUX 50.
Internal error – This status byte indicates that a malfunction has been discovered
that could cause the instrument to operate incorrectly.
Device–dependent event – This status byte is set when there is an event specific
to the 370B.
To Next Page
Loading...