Getting Started
1-12
370B User Manual
5. Push the instrument into the rack, and check that the automatic spring latch
engages the spring latch catch to hold the instrument in place.
6. Extend the instrument out of the rack by pulling the rackmount latch releases
on the front panel (see Figure 1–2) out to disengage the spring latches. Then,
pull the instrument out.
7. Once the instrument is out of the rack, press the latch release and push the
instrument back into the rack.
To convert the 370B rackmount version to a cabinet model, use the following
procedure (see Figure 1–7):
1. Remove the bracket from each comer of the instrument rear panel.
2. Replace the left and right side panels with cabinet model side panels.
3. Mount a carrying handle assembly on the left and right sides of the top.
4. Fasten a foot at each corner on the bottom of the instrument.
Rackmount to Cabinet
Conversion
To Next Page
Loading...
General