370B User Manual
2-1
Operating Basics
This section provides the following information:
Front panel controls and connectors
Rear panel controls and connectors
Controls and Connectors
All controls, indicators and connectors required for manual operation of the
370B are located on the front and rear panels of the instrument. In addition,
readout of the controls and measurement functions is provided on the CRT.
This section includes the descriptions of the functions of the controls, selectors,
indicators and connectors, which are shown and identified in Figures 2–1
through 2–10. Readout of the controls and measurement functions is provided on
the CRT.
The front panel controls are grouped and described in the following subsections:
Instrument Power and CRT Controls
Measurement, ACQ Mode (Store Mode), and Mag Controls
Memory Index and Setup Controls
Display Controls
Cursor and Position Controls
Step Generator Controls
Collector Supply Controls
Aux Supply, GPIB, FAST/SHIFT, and Floppy Disk Drive Controls
Signal Input and Output Controls, Connectors, Configurations and Indicators
Front Panel
To Next Page
Loading...