Sequence
Editing a Sequence
The following commands are provided for sequence edit:
Set Waveform a
nd Insert Waveform.
Use these menus to set or insert a waveform to a Sequence window cell.
Clear. Clear removes the contents of selected element(s). You can clear multiple non-contiguous elements. Unselected
elements do not shift.
Cut and Delete. Cut and Delete can be done by the units of element. You can cut or delete multiple and continuous
elements at a time.
Copy, Paste-Insert and Paste-Replace. You can copy or paste data on one or more contiguous elements. The
data in the clipboard will be inserted or replaced at the specified position of the sequence. If Paste-Insert is executed,
the existing data is shifted.
Edit Example
The following procedure shows Cut and Paste example in the Sequence window (Table display).
1. Create a sequence.
2. Select the element(s) to cut. In this
example, Index number 3 is the target
of Cut.
NOTE. You can Cut and Delete at the units
of element level.
74 AWG5000 and AWG7000 Series Quick Start User Manual
To Next Page
Loading...
