Commands Listed in Alphabetical Order
DELEte:WAVEf
orm (No Query Form)
This command (no query form) deletes one or all of the stored reference
waveforms from memory. The memory allocated for the reference location is
then availab
le for reallocation.
NOTE. A reference waveform cannot be dele ted if it is a source client for some
other operation, such as a histogram source, math source, measurement, or
waveform database.
Group
Save and Recall
Syntax
DELEte:WAVEform { REF<x> | ALL }
Related Commands
RECAll:WAVEform, SAVe:WAVEform
Arguments
REF<x> speciļ¬es one of the reference memory locations (REF1 through
REF8).
ALL speciļ¬es all the stored reference waveforms.
Examples
DELETE:WAVEFORM ALL removes all the waveforms stored in reference memory.
DELETE:WAVEFORM REF2 removes the waveform stored at REF2.
DESE
This command sets or queries the bits in the Device Event Status Enable Register
(DESER). The DESER is the mask that determines whether events are reported
to the Standard Event Status Register (SESR) and entered into the Event Queue.
For a more detailed discussion of the use of these registers, see Registers for
more information.
Group
Status and Error
Syntax
DESE <N R1>
DESE?
Related Commands
*CLS, *ESE, *ESR?, EVENT?, EVMsg?, *SRE, *STB?
DSA/CSA/TDS8X00/B Series Programmer Manual 2-115
To Next Page
Loading...
Need help?
General
