Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
HORizontal:R
EF<x>:MAIn:TOLPoint? (Query Only)
This query only command returns time of last point of the specified reference
record (waveform) using the Main timebase. The time of last point is the time
interval bet
ween the trigger point and the last point in the specified Reference
Main timebase record.
Group
Horizontal
Syntax
HORizontal:REF<x>:MAIn:TO LPoint?
Related Commands
HORizontal:REF<x>:MAIn:POSition?, HORizontal:REF<x>:MAIn:REFPoint?,
HORizontal:REF<x>:MAIn:SCAle?
Examples
HORIZONTAL:REF3:MAIN:TOLP OINT? might return
HORIZONTAL:REF3:MAIN:TOLP OINT 51.30000000000E-009, indicating that
the time interval between the trigger point and the last point in the Reference
3Maintimebas
erecordis51.3ns.
HORizontal:TBMode
This command sets or queries the timebase mode. Sending this command is
equivalent to making a selection in the Mode control in the All Timebases section
of the Horizontal Setup dialog box.
Group
Horizontal
Syntax
HORizontal:TBMode {SHORTTerm | LOCKExt | LOCKInt}
HORizontal:TBMode?
Arguments
SHORTTerm enables the horizontal timebase mode, which gives the best
short-term jitter.
LOCKExt enables the Lock to Ext. 10 MHz mode, which locks the timebase
to an external 10 MHz reference signal.
LOCKInt enables the Lock to Int. 10 MHz mode, which locks the timebase to
the internal 10 MHz reference signal. This mode yields exceptional long-term
horizontal stability.
2-192 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English