Commands Listed in Alphabetical Order
*LRN? (Query O
nly)
This query only command returns a string listing the instrument settings, except
for configuration information for the calibration values. You can use this string to
return the in
strument to the state it was in when you made the *LRN? query. This
command is identical to the SET? query.
Group
Miscellan
eous
Syntax
*LRN?
NOTE. The *LRN? query always returns a string including command headers,
regardless of the setting of the HEADer command. This is because the returned
string is intended to be sent back to the instrument as a command string. The
VERBose command can still be used normally to specify whether the returned
headers should be abbreviated.
Related Commands
HEADer, SET? , VERBose
Examples
*LRN? might return ACQUIRE:STAT E 1;MODE SAM PLE; NUMENV
10;NUMAVG 16; REPET 1; STOPAFTER RUNSTOP; :DIAG:LOOP:OPTION
ONCE; C OUNT 1; :DIAG:STATE HALT; :HEADER 1;:VERBOSE 1;
CURSOR:FUNCTION OFF; VBARS:UNITS SECONDS; POSITION1 1.00E–6;
POSITION2 9.00E–6; SEL ECT CURSOR1
.
MASK? (Query Only)
This query only command returns the status of all settable mask parameters.
Group
Mask
Syntax
MASK?
Examples
MASK? might return MASK:AUTOS:MOD MAN; HIL:METH MEAN; :MASK:STAN
OC12; C OLO 4; COUN :STATE 1; TOT 617435; WAV 3811;SAMP
1905500; MASK:DIS 1;MA R:PERC 0.0000;STATE 1 ; MASK:MASK1:COUN
0; NR_P 4; POI 20.69040050401E–9,0 .00100000005,
20.69499949187E–9,799.999 97979030E–6,
22.30039974904E–9,799.999 97979030E–6,
22.30500051326E–9,0.00100 000005;
POINTSP14.8296,0.0000,15. 0300,10.0250,
2-196 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
