Commands Listed in Alphabetical Order
84.9699,10.02
50,85.1703,0.0000; MASK:MASK2:COUN
617435;NR_P 6; POI 21.09520025328E-9,0.0000,
21.33899990042E–9,–340.540 54412991E–6,
21.65639934049E–9,–340.540 54412991E–6,
21.90020076398E–9,0.0000,
21.65639934049E–9,345.9459 4035298E–6,
21.3389999
0042E–9,345.94594035298E–6;
POINTSP 32.4649,50.1253,43.0861,67.1679,
56.9138,67.1679,67.5350,50 .1253,56.9138,
32.8320,43.0861,32.8320; MASK:MASK3:COUN
0;NR_P 4; POI 20.69040050401E–9,-0.00100000005,
22.30500051326E–9,–0.00100 000005,
22.30039
974904E–9,–799.99997979030E –6,
20.69499949187E–9,–799.999 97979030E–6;
POINTSP 14.8296,100.2506,85.1703,100.2506 ,
84.9699,90.2255,15.0300,90 .2255; MASK:MASK4:COUN –1;NR_P
0; POI 0,0; POINTSP 0,0;:MASK:MASK 5:COUN –1; NR_P 0;POI
0,0;POINTSP 0,0; :MASK :MASK6:COUN –1; NR_P 0;POI 0,0;POINTSP
0,0; :
MASK:MASK7:COUN –1; NR_P 0;POI 0,0;POINTSP 0,0;
:MASK:MASK8:COUN –1; NR_P 0;POI 0,0;POINTSP 0,0; :MASK:SOU
CH1,MAIN; WFMDB:STATE 1
.
MASK
:AUTOSet:HILow:METHod
This command sets or queries the method used for determining the High value and
Low value used when aligning the input signal to NRZ eye masks. The method set
wi
ll be used when Autoset executes on a mask source (that is, when a mask source
is the currently selected waveform). The query form of this command returns the
current method set for Mask Autoset.
The default Mask Autoset High/Low method is MEAN. The use of this command
is equivalent to setting the HiLow Method in the Mask Autoset section of the
Mask Setup dialog box.
Group
Mask
Syntax
MASK:AUTOSet:HILow:METHod {MEAN | MODe}
MASK:AUTOSet:HILow:METHod?
Related Commands
AUTOSet, MASK:AUTOSet:MODe, MASK:STANdard
DSA/CSA/TDS8X00/B Series Programmer Manual 2-197
To Next Page
Loading...
Need help?
General
