Commands Listed in Alphabetical Order
0;SIGTYPE PULS
E;:MEASUREMENT:MEAS1 SOURCE1:GATE1:P OS
1.80000000000E-008;
...
MEASUrement:ALL:VALue? (No Query Form)
This query only command returns all the measurement values.
Group
Measurement
Syntax
MEASUrement:ALL:VALue?
Related Commands
MEASUrement:LISTValue?, MEASUrement:MEAS<x>:VALue?
Examples
MEASUREMENT:ALL:VALUE? might return M EASUREMENT:ALL:VALUE
5.18798842266E
-004, 1. 08967389191E-010 ,99.10000000000E+36,
1.57041666667E-009,6.3677 36800021E+008,
99.10000000000E+36,4.1136 8599818E-001", 99.10000000000E+ 36
as
the listing of the eight p ossible measurement values.
NOTE. The value 99.10000000000E+36 in the returned list of values is the
numeric equivalent to NAN (not a number); this value indicates that the
measurement
slot does not have a valid measurement defined for it.
MEASUremen
t:ANNOtations:STATE
This command sets or queries whether annotations are displayed. This is
equivalent to toggling the Annotations check b ox in the Measurement Setup
dialog box
. To d isplay gates used in gated measurements, Gates must be e n abled
with the MEASUrement:MEAS<x>:GATing:STATE command.
Group
Measurement
Syntax
MEASUrement:ANNOtations:S TATE { ON | OFF | NR1 }
MEASUrement:ANNOtations:S TATE?
Related Commands
MEASUrement:MEAS<x>:GATing:STATE
2-222 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
