Commands Listed in Alphabetical Order
Syntax
WFMOutpre:ENC
dg {ASCIi | BINary}
WFMOutpre:ENCdg?
Related Commands
DATa:ENCdg, WFMOutpre:BYT_Or, WFMOutpre:BN_Fmt, CURVe
Arguments
ASCIi sets the encoding for waveform data transfer to ASCIi curve data. The
output will be formatted to floating point or integer, based on how the data
is stored in the instrument.
BINary sets the encoding for the waveform data transfer to binary format.
This will coerce DATA:ENCdg to a corresponding setting based on binary
format and order.
Examples
WFMOUTPRE:ENCDG ASCII specifies that the waveform data is in ASCII format.
WFMOUTPRE:ENCDG? might return WFMOUTPRE:ENCDG BINARY, indicating that
the waveform data is in binary format.
WFMOutpre:NR_Pt? (Query Only)
This is a query only command that returns the number of points that were returned
by the previous CURVe? command. The number of points is the greater of the
absolute value of (DATa:STOP - DATa:STARt) +1, or the record length o f the
source waveform specified by the DATa:SOUrce command.
Group
Waveform Transfer
Syntax
WFMOutpre:NR_Pt??
Related Commands
CURVe, DATa:STOP, DATa:STA Rt, DATa:SOUrce, DATa:TIMebase
Examples
WFMOUTPRE:NR_PT? might return WFMOU TPRE:NR_PT 500.
WFMOutpre:PT_Fmt? (Query Only)
This is a query only command that returns the data point format of the w aveform
returned by the previous CURVe? command.
Group
Waveform Transfer
DSA/CSA/TDS8X00/B Series Programmer Manual 2-367
To Next Page
Loading...
Need help?
General
