Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
WFMOutpre:BYT_Nr?
Related Commands
WFMOutpre:BIT_Nr?
Examples
WFMOUTPRE:BYT_NR? might return WFMOUT PRE:BYT_NR 4, indicating that
the byte width for waveform data is 4.
WFMOutpre:BYT_Or
Selects which byte of binary waveform data is transmitted first during a
waveform data transfer. If binary encoding is selected, this command will coerce
DATa:ENCdg to corresponding settings based on the binary format and order.
G
roup
Waveform Transfer
Syntax
WFMOutpre:BYT_Or {LSB | MSB}
WFMOutpre:BYT_Or?
Related Commands
DATa:ENCdg, WFMOutpre:BN_Fmt, WFMOutpre:ENCdg
Arguments
LSB selects the least-significant byte to be transmitted fi rst.
MSB selects the most-significant byte to be transmitted first.
Examples
WFMOUTPRE:BYT_OR MSB specifies that the most-significant byte in the
waveform data will be transferred first.
WFMOUTPRE:BYT_OR? might return WFMOUTPRE:BYT_O MSB, indicating that the
most-significant byte in the waveform data will be transmitted first.
WFMOutpre:ENCdg
This command sets or queries the type of encoding used for waveform data
transferred with the CURVe? command. Using this command to change the type
of encoding also changes the encoding set by the DATA:ENCdg command.
Group
Waveform Transfer
2-366 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English