Tektronix MDO3024 User Manual

Save and Recall I
nformation
14. When done, push OK Accept.
Printing with One Button Push
Once you have
connected a printer to your oscilloscope and set up print parameters, you can print current screen images with
a single push of a button:
Push the pri
nter icon button in the lower left
corner of the front panel.
Using Oscilloscope Security Features
Erasing Oscilloscope Memory
The MDO3000 provides optional enhanced security to enable password protected control of turning on/off all instrument ports.
You can erase all setup and waveform information saved in the nonvolatile oscilloscope memory with the TekSecure function.
If you have acquired confidential data on your oscilloscope, you may want to execute the TekSecure function before you
return the oscilloscope to general use. The TekSecure function:
Replaces all waveforms in all reference memories with null values
Replaces the current front panel setup and all stored setups with the default setup
Displays a confirmation or warning message, depending on whether the verification is successful or unsuccessful
With the MDO3SE C option, you can also turn the I/O ports on or off and turn the firmware upgrade capability on or off.
To use TekSecure, without the MDO3SEC application module installed:
1. Push Utility.
2. Push Utility Page.
Utility
Page
3. Turn the Multipur pose a knob and select
Security.
Security
180 MDO3000 Series Oscilloscopes User Manual

Tektronix MDO3024 Specifications

General

Analog Channels	4
Bandwidth	200 MHz
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Digital Channels	16 (optional)
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Digital Voltmeter	4-digit
Vertical Resolution	8 bits
Operating Temperature	0 °C to +50 °C
Display	9-inch WVGA (800x480) color display
Connectivity	USB, LAN, GPIB (optional)
Arbitrary Function Generator	50 MHz
Trigger Modes	Edge, Pulse Width, Logic, Video, Runt, Rise/Fall Time, Setup/Hold
Input Impedance	1 MΩ ±1%
Max Input Voltage	300 VRMS
Trigger Types	Edge, Pulse Width, Logic, Video, Runt, Rise/Fall Time, Setup/Hold