Tektronix MDO3024 User Manual

Installation
3. TPA-BNC Adapter
The TPA-BNC Adapter allows you to
use TEKPROBE I
I probe capabilities,
such as providing probe power, and
passing scaling and unit information to
the oscillos
cope.
4. BNC Interfa
ces
Some of these use TEKPROBE
capabilities to pass the waveform signal
and scaling
to the oscilloscope. Some
only pass the signal and there is no other
communication.
5. Logic Probe Interface
The P6316 p
robe provides 16 channels
of digital (on or off state) information.
6. The TPA-N
-VPI Adapter allows you to
use TekVPI probes in the RF input.
For m ore information on the many probes available for use with MDO3000 Series oscilloscopes, visit the Oscilloscope Probe
and Accessory Selector Tool on the Tektronix website at www.tektronix.com.
Securi
ng the Oscilloscope
1. Use a st
andard laptop computer style
security lock to secure your oscilloscope
to your location.
8 MDO3000 Series Oscilloscopes User Manual

Tektronix MDO3024 Specifications

General

Analog Channels	4
Bandwidth	200 MHz
Sample Rate	2.5 GS/s
Record Length	10 Mpoints
Digital Channels	16 (optional)
Spectrum Analyzer Frequency Range	9 kHz to 3 GHz
Digital Voltmeter	4-digit
Vertical Resolution	8 bits
Operating Temperature	0 °C to +50 °C
Display	9-inch WVGA (800x480) color display
Connectivity	USB, LAN, GPIB (optional)
Arbitrary Function Generator	50 MHz
Trigger Modes	Edge, Pulse Width, Logic, Video, Runt, Rise/Fall Time, Setup/Hold
Input Impedance	1 MΩ ±1%
Max Input Voltage	300 VRMS
Trigger Types	Edge, Pulse Width, Logic, Video, Runt, Rise/Fall Time, Setup/Hold