Commands Listed in Alphabetical Order
CONFIGuratio
n:AFG? (Query Only)
Indicates whether or not the arbitrary function generator hardware is present, and
the arbitrary function generation feature is enabled.
Conditions
Available for MDO3000 and MDO4000C series models only.
Group
Configuration
Syntax
CONFIGuration:AFG?
Returns
1 indicates that the arbitrary function generator hardware is present and the AFG
feature is enabled.
0 indicates that either the arbitrary function generator hardware is not present,
or the feature is not enabled.
Examples
CONFIG:AFG? might return 1, indicating that the hardware is present and the
feature is enabled.
CONFIGuration:ANALOg:BANDWidth? (Query Only)
This query returns the bandwidth, in Hz, for the analog channels.
Group
Configuration
Syntax
CONFIGuration:ANALOg:BANDWidth?
Related Commands
(See page 2-29, Horizontal Command Group.)
Returns
<NR3>, which is a floating point number that represents the bandwidth, in hertz,
for the analog channels.
CONFIGuration:ANALOg:GNDCPLG? (Query Only)
This query returns a boolean value to indicate whether the ground coupling
feature for analog channels is present. As this feature is not supported on
MSO/DPO4000B, MDO4000/B/C or MDO3000 models, this query always
returns 0.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-237
To Next Page
Loading...
Need help?
General
