Commands Listed in Alphabetical Order
Group
Cursor
Syntax
CURSor:HBArs?
Examples
CURSOR:HBARS? might return the horizontal
bar setting as
:CURSOR:HBARS:POSITION1
320.0000E-03;POSITION2-320.0000E-03;UN ITS BASE
CURSor:HBArs:DELTa ? (Query Only)
Returns the vertical difference between the two horizontal bar cursors.
Group
Cursor
Syntax
CURSor:HBArs:DELTa?
Related Commands
CURSor:HBArs:UNIts
Returns
A floating point value with an exponent.
Examples
CURSOR:HBARS:DELTA? might return :CURSOR:HBARS:DELTA 5.0800E+00
indicating that the difference between the two cursors is 5.08.
CURSor:HBArs:POSITION<x>
This command specifies the horizontal bar cursor position relative to ground,
whichisexpressedinverticalunits(usually volts). The cursor is specified by
x,whichcanbe1or2.
Group
Cursor
Syntax
CURSor:HBArs:POSITION<x> <NR3>
CURSor:HBArs:POSITION<x>?
Related Commands
CURSor:FUNCtion
2-258 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
