Commands Listed in Alphabetical Order
Syntax
CURSor:SOUrce
{CH1|CH2|CH3|CH4|REF1|REF2|REF3|REF4|MAT H
|BUS1|BUS2|BUS3|BUS4|D0|D1|D2|D3|D4|D5 |D6|D7|D8|D9|D10
|D11|D12|D13|D14|D15|RF_AMPlitude|RF_F REQuency|RF_PHASe|AUTO}
CURSor:SOUrce?
Related Commands
SELect:CONTROl,
CURSor:MODe,
CURSor:FUNCtion
Arguments
CH1-4 – specifies one of the analog waveforms as the cursor source.
REF1-4 – specifies one of the reference waveforms as the cursor source.
MATH – specifies the cursor source as the math waveform.
BUS1-4 – specifies the cursor source as one of the bus waveforms.
D0–D15 – specifies the cursor source as one of the digital waveforms.
(MSO/MDO4000/B models only as well as MDO3000 and MDO400C models
with option MDO3MSO or MDO4MSO installed.)
RF_AMPlitude|RF_FREQuency|RF_PHASe – specifies the cursor source as one
of the RF time domain traces (Amplitude vs. Time, Frequency vs. Time or Phase
vs. Time). (MDO4000/B/C series models only.)
AUTO – specifies the currently selected waveform. The selected waveform can be
determined by querying SELect:CONTROl
Examples
CURSor:SOUrce CH3 sets the cursor source to Channel 3.
CURSor:SOUrce? might return AUTO, indicating that the cursor source has been
set to the currently selected waveform.
CURSor:VBArs? (Query Only)
Returns the current settings for the vertical bar cursors.
Group
Cursor
Syntax
CURSor:VBArs?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-261
To Next Page
Loading...
Need help?
General
