Commands Listed in Alphabetical Order
Arguments
CURrent sets th
e V Bar measurement scale so that 0% is the current position of
the left-most V Bar cursor and 100% is the current position of the right-most
VBarcursor.
HALFgrat resets the ratio range to the default positions on the screen, half
of the number of horizontal divisions (five on the MSO/DPO4000B and
MDO4000/B/C), from 25% to 75% of the screen.
FIVEdivs sets V Bar measurement scale so that 5 screen major divisions is
100%, where 0% is -2.5 divisions and 100% is +2.5 divisions from the center
vertical graticule.
Examples
CURSOR:VBARS:USE CURRENT sets the V Bar measurement scale to use the
current cursor positions as 0% and 100% of scale if units are set to %.
CURSor:VBArs:VDELTa? (Query Only)
Returns the vertical difference between the two vertical bar cursor ticks.
Group
Cursor
Syntax
CURSor:VBArs:VDELTa?
Related Commands
CURSor:HBArs:UNIts
Returns
<NR3> indicates the vertical difference between the two vertical bar cursors' ticks.
Examples
CURSOR:VBARS:VDELTA? might return CURSOR:VBARS:VDELTA 1.064E+0,
indicating that the vertical difference between the vertical bar cursors ticks is
1.064 units.
CURSor:XY:POLar:RADIUS:DELta? (Query O nly)
Returns the difference between the cursors X radius and the cursor Y radius (ΔY¸
ΔX). The ratio is calculated as (cursor 2 Y - cursor 1 Y) ÷ (cursor 2 X - cursor 1 X).
Group
Cursor
Syntax
CURSor:XY:POLar:RADIUS:DELta?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-265
To Next Page
Loading...
Need help?
General
