Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Syntax
CURSor:XY:RAT
IO:DELta?
CURSor:XY:RATIO:POSITION<x>? (Query Only)
Returns the X (horizontal) or Y (vertical) position for the specified cursor, which
can be 1 (X) or 2 (Y). The ratio is calculated as Position 1 = (Y1/X1); Position
2 = (Y2/X2).
Group
Cursor
Syntax
CURSo
r:XY:RATIO:POSITION<x>?
CURSor:XY:RATIO:UNIts? (Query Only)
Returns the cursor X and cursor Y units for the ratio measurement.
Group
Cursor
Syntax
CURSor:XY:RATIO:UNIts?
CURSor:XY:READOUT
This command specifies the XY cursor re
adout selection.
Group
Cursor
Syntax
CURSor:XY:READOUT {RECTangular|POLARCord|PRODuc t|RATio}
CURSor:XY:READOUT?
Arguments
RECTangular specifies the XY readout as recta
ngular coordinates.
POLARCord specifies the XY readout as polar coordinates.
PRODuct specifies the XY readout in X*Y format.
RATio specifies the XY readout in X:Y format.
2-268 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English