Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
HORizontal:D
IGital:SAMPLERate:MAIn? (Query Only)
Returns the sample rate of the main digital acquisition.
Group
Horizontal
Syntax
HORizontal:DIGital:SAMPLERate:MAIn?
HORizontal:POSition
This command specifies the horizontal position, in percent, that is used when
delay if off. If Horizontal Delay Mode is turned off, this command is equivalent
to adjusting the HORIZONTAL POSITION knob on the front panel. When
Horizontal Delay Mode is on, this command stores a new horizontal position that
is used when Horizontal Delay Mode is turned off.
Group
Horizontal
Syntax
HORizontal:POSition <NR3>
HORizontal:POSition?
Related Commands
HORizontal:DELay:TIMe
Arguments
<NR3> is a floating point number that specifies the horizontal position expressed
as the percentage of the waveform acquired before the trigger.
Examples
HORIZONTAL:POSITION 50 sets the horizontal position to 50%.
HORIZONTAL:POSITION? might return :HORIZONTAL:POSITION 100
indicating that the horizontal position is set to 100%.
HORizontal:PREViewstate? (Query Only)
Returns a boolean value to indicate whether the display system is in the preview
state.
Group
Horizontal
Syntax
HORizontal:PREViewstate?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-347

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English