Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
MEASUREMENT:G
ATING?
might return :MEASUREM ENT:GATING CURSOR
indicating that measurements are limited to the portion of the waveform between
the vertical bar cursors.
MEASUrement
:IMMed? (Query Only)
Returns all immediate measurement setup parameters.
Group
Measurement
Syntax
MEASUrement:IMMed?
Examples
MEASUREMENT:IMMED? might return
:MEASUREMENT:IMMED:DELAY:DIRECTION FORWARDS;EDGE1 RISE;EDGE2
RISE;:MEASUREMENT:IMMED:TYPE PERIOD;UNITS "s";SOURCE1
CH1;SOURCE2 CH2
MEASUrement:IMMed:DELay? (Query Only)
Returns information about the immediate delay measurement. This command is
equivalent to viewing the delay measurement settings on the measurement readout.
Group
Measurement
Syntax
MEASUrement:IMMed:DELay?
Examples
MEASUREMENT:IMMED:DELAY? might return
:MEASUREMENT:IMMED:DELAY:DIRECTION FORWARDS; EDGE1
RISE;EDGE2 RISE
MEASUrement:IMMed:DELay:DIRection
This command specifies the starting point and direction that determines the delay
"to" edge when taking an immediate delay measurement.
NOTE. Use the MEASUrement:IMMed:SOUrce<x> command to specify the
delay "to" waveform.
2-422 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English