Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
Examples
MEASUREMENT:I
NDICATORS:STATE MEAS2
turns on the display of visible
measurement indicators for measurement 2.
MEASUREMENT:
INDICATORS:STATE?
might return
MEASUREMENT:INDICATORS:STATE OFF indicating that no measurement
indicators are active.
MEASUremen
t:INDICators:VERT<x>? (Query Only)
Returns the value of the specified vertical measurement indicator <x> from the
trigger point, where <x> can be 1 through 8. A negative value means that the
indicato
r is positioned earlier in the waveform record than the trigger point.
Group
Measurement
Syntax
MEASUrement:INDICators:VERT<x>?
Examples
MEASUREMENT:INDICATORS:VERT2? might return
MEASUREMENT:INDICATORS:VERT2 -3.724507E-6 indicating that the
second measurement indicator is positioned 3.72 μs before the trigger point.
MEASUrement:MEAS<x>? (Query Only)
Returns all measurement parameters
for the specified active measurement <x>.
Group
Measurement
Syntax
MEASUrement:MEAS<x>?
MEASUrement:MEAS<x>:COUNt? (Query Only)
Returns the number of values accumulated for this measurement since the last
statistical reset. Values may be ignored if they generated an error. Measurements
are specified by x, which ranges from 1 through 8.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:COUNt?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-433

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English