Commands Listed in Alphabetical Order
POWer:INDICa
tors
This command specifies the state of the measurement indicators for the power
application.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for
MDO3000 series models.
Group
Power
Syntax
POWer:INDICators {OFF|ON|0|1}
POWer:INDICators?
Arguments
OFF or 0 turns off the measurement indicators.
ON or 1 turns on the measurement indicators.
Examples
POWER:INDICATORS 1 turns on the indicator.
POWER:INDICATORS? might return :POWER:INDICators 0 indicating that
the indicator is off.
POWer:MODulation:SOUrce
This command specifies the source waveform for modulation tests. The voltage
source waveform is specified using the POWer:VOLTAGESOurce command and
the current waveform is specified using the POWer:CURRENTSOurce command.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:MODulation:SOUrce {VOLTage|CURRent}
POWer:MODulation:SOUrce?
Arguments
VOLTage specifies voltage source waveform for modulation tests.
CURRent specifies current source waveform for modulation tests.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-487
To Next Page
Loading...
Need help?
General
