Tektronix MDO4000B Series - Page 521

Commands Listed in Alphabetical Order
POWER:QUALITY
:DISPLAY:ICRESTFACTOR?
might return
:POWER:QUALITY:DISPLAY:ICRESTFACTOR 0 indicating that the
current crest factor display is off.
POWer:QUALi
ty:DISplay:IRMS
This command specifies the display state for the rms current readout.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:DISplay:IRMS {OFF|ON|0|1}
POWer:QUALity:DISplay:IRMS?
Arguments
OFF or 0 turns off the rms current display.
ON or 1 turns on the rms current display.
Examples
POWER:QUALITY:DISPLAY:IRMS 1 turns on the rms current display.
POWER:QUALITY:DISPLAY:IRMS? might return
:POWER:QUALITY:DISPLAY:IRMS 0 indicating that the rms current display
is off.
POWer:QUALity:DISplay:PHASEangle
This command specifies the display state for the phase angle readout.
Conditions
Th
is command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:DISplay:PHASEangle {OFF|ON|0|1}
POWer:QUALity:DISplay:PHASEangle?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-491