Tektronix MDO4000B Series - Page 523

Commands Listed in Alphabetical Order
Syntax
POWer:QUALity
:DISplay:REACTpwr {OFF|ON|0|1}
POWer:QUALity:DISplay:REACTpwr?
Arguments
OFF or 0 turns off the reactor power display.
ON or 1 turns on the reactor power display.
Examples
POWER:QUALITY:DISPLAY:REACTPWR 1 turns on the reactor power display.
POWER:QUALITY:DISPLAY:REACTPWR? might return
:POWER:QUALITY:DISPLAY:REACTPWR 0 indicating that the reactor power
display is off.
POWer:QUALity:DISplay:TRUEpwr
This command specifies the display state for the true power readout.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PW
R application module for MDO3000 series models.
Group
Power
Syntax
POWer:QUALity:DISplay:TRUEpwr {OFF|ON|0|1}
POWer:QUALity:DISplay:TRUEpwr?
Arguments
OFF or 0 turns off the true power display.
ON or 1 turns on the true power display.
Examples
POWER:QUALITY:DISPLAY:TRUEPWR 1 turns on the true power display.
POWER:QUALITY:DISPLAY:TRUEPWR? might return
:POWER:QUALITY:DISPLAY:TRUEPWR 0 indicating that the true power
display is off.
POWer:QUALity:DISplay:VCRESTfactor
This command specifies the display state for the voltage crest factor readout.
Conditions
This command requires a DPO4PWR application module for 4000 series models,
or an MDO3PWR application module for MDO3000 series models.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-493