Tektronix MDO4000B Series - Page 757

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:LOGIc:PATtern:WHEn:LESSLimit
This command specifies the maximum time that the selected pattern may be true
and still generate an A logic pattern search to place a mark. <x> is the search
number, whic
hisalways1
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:PATte rn:WHEn:LESSLimit
<NR3>
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:PATte rn:WHEn:LESSLimit?
Arguments
<NR3> is a floating point number that specifies the maximum amount of time
to hold the pattern true.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:PATtern:WHEn:MORELimit
This command specifies the minimum time that the sele
cted pattern may be true
and still generate an A logic pattern search to place a mark.
SEARCH<x> is the
search number, which is always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:PATte rn:WHEn:MORELimit
<NR3>
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:PATte rn:WHEn:MORELimit?
Arguments
<NR3> is a floating point number that specifies the minimum amount of time
to hold the pattern true.
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THReshold:CH<x>
This command specifies the channel threshold level for a logic search to determine
wheretoplaceamark.
SEARCH<x> is the search number, which is always 1, and
CH<x> is the channel number, which can be 1–4.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:CH<x> {<NR3>|TTL}
SEARCH:SEARCH<x>:TRIGger:A:LOGIc:THRes hold:CH<x>?
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-727