Tektronix MDO4000B Series

Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:RUNT:WIDth <NR3>
SEARCH:SEARCH<x>:TRIGger:A:RUNT:WIDth?
Arguments
<NR3> is a floating point number that specifies the minimum width, in seconds.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:EDGE
This command specifies the clock slope setting for a setup/hold search to
determine where to place a mark.
SEARCH<x> is the search number, which is
always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLO Ck:EDGE {FALL|RISe}
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLO Ck:EDGE?
Arguments
FALL specifies polarity as the clock falling edge.
RISe specifies polarity as the clock rising edge.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:SOUrce
This co
mmand specifies the clock source setting for a setup/hold search to
determine where to place a mark.
SEARCH<x> is the search number, which is
always 1.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLO Ck:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF1|REF3|REF3|R EF4|D0|D1|D2|D3|D4
|D5|D6|D7|D8|D9|D10|D11|D12|D13|D14|D1 5|RF_AMPlitude|
RF_FREQuency|RF_PHASe}
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLO Ck:SOUrce?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:SOUrce
Arguments
CH1–4 specifies an analog channel as the clock source waveform.
MATH specifies the math waveform as the clock source waveform.
REF1–4 specifies a reference waveform as the clock source waveform.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-741